answered
2016-07-21 09:35:16 +0200
dmnk 2726 ●39 ●59 ●65
for full comparability: the diff between the outputs of the both phones, so one can see what are the differences over all possible capabilities.
--- <Jolla1>
+++ <JollaC>
@@ -1,8 +1,8 @@
Wiphy phy0
max # scan SSIDs: 9
- max scan IEs length: 200 bytes
- max # sched scan SSIDs: 0
- max # match sets: 0
+ max scan IEs length: 500 bytes
+ max # sched scan SSIDs: 16
+ max # match sets: 16
Retry short limit: 7
Retry long limit: 4
Coverage class: 0 (up to 0m)
@@ -12,6 +12,7 @@
* TKIP (00-0f-ac:2)
* CCMP (00-0f-ac:4)
* WPI-SMS4 (00-14-72:1)
+ * CMAC (00-0f-ac:6)
Available Antennas: TX 0 RX 0
Supported interface modes:
* IBSS
@@ -45,8 +46,8 @@
* 2452 MHz [9] (20.0 dBm)
* 2457 MHz [10] (20.0 dBm)
* 2462 MHz [11] (20.0 dBm)
- * 2467 MHz [12] (20.0 dBm)
- * 2472 MHz [13] (20.0 dBm)
+ * 2467 MHz [12] (19.0 dBm)
+ * 2472 MHz [13] (19.0 dBm)
* 2484 MHz [14] (disabled)
Bitrates (non-HT):
* 1.0 Mbps
@@ -76,18 +77,29 @@
* frame
* frame_wait_cancel
* set_channel
+ * tdls_mgmt
+ * tdls_oper
+ * start_sched_scan
+ * testmode
* connect
* disconnect
Supported TX frame types:
+ * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
* P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0
Supported RX frame types:
+ * IBSS: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* managed: 0x40 0xd0
* AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
* P2P-client: 0x40 0xd0
* P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0
software interface modes (can always be added):
- interface combinations are not supported
+ valid interface combinations:
+ * #{ managed } <= 3, #{ IBSS, AP } <= 1, #{ P2P-client, P2P-GO } <= 1,
+ total <= 3, #channels <= 2
+ Device supports HT-IBSS.
+ Device supports scan flush.
Device supports roaming.
+ Device supports T-DLS.