Sony XA2 turns off

asked 2019-07-28 23:00:01 +0200

sd gravatar image

updated 2019-07-28 23:03:02 +0200

After several hours of use, the OS freeze, the screen turns off and does not turn on. Red LED is on.

I use: Sony XA2 4113 Rev2, Sailfish_OS-Jolla-3.1.0.11-h4113-0.0.7.19, SW_binaries_for_Xperia_Android_8.1.6.4_r1_v17_nile

This is repeated several times, usually when charging the battery at about 60%. But there is a connection to the phone via the ssh.

dmesg gives out:

[ 9960.337120] ICE_TEST_BUS_CONTROL: 0xd00f0001 | ICE_TEST_BUS_REG: 0x00000000 [ 9960.337187] sdcc: ICE reset start time: 9959316042287 ICE reset done time: 9959316108642 [ 9960.338323] sdcc: Time taken for reset: 66 [ 9960.338429] mmc0: clk: 400000 clk-gated: 0 claimer: mmc-cmdqd/0 pwr: 10 host->irq = 16384 [ 9960.338434] mmc0: rpmstatuspltfm(0:6641:0) [ 9960.338436] sdhci: =========================================== [ 9960.350059] mmc0: CMD13 failed with err -110 [ 9960.350207] mmc0: Timeout error detected with device status 0x00000000

After that, the OS freezes and does not respond to pressing buttons. Power and volume up turns off the phone completely and for the next switch it is required to wait for the battery full discharge. What is the problem?

edit retag flag offensive close delete

Comments

same problem i have opened a question. i personally prefer to open the phone and disconnect the battery then wait till battery is drained...

toba ( 2019-07-28 23:19:21 +0200 )edit

Just fishing here, but do you happen to have an SD card inserted?

If so, have you tried removing it and seeing if it is the cause of the lockups?

Durney

durneyj ( 2019-07-28 23:49:08 +0200 )edit

I do not have a SD card. It seems to be a problem with the MMC flash. On the standard firmware there are no problems. Perhaps a problem with the binaries drivers from Sony? They have different versions, I use the latest.

sd ( 2019-07-28 23:57:36 +0200 )edit

Ah, OK. I had problems with a bad SD card recently.

Personally, I found v16 to be better than v17B.

You could try flashing just the binaries..

The guide is here if you need it:

https://jolla.zendesk.com/hc/en-us/articles/360019346354-How-can-I-update-the-Sony-vendor-image-for-Xperia-XA2-?mobile_site=true

durneyj ( 2019-07-29 01:05:56 +0200 )edit

I tried the v16 driver version and got the same result. And the same effect on custom Android(Lineage OS). Only official firmware works on my hardware.

sd ( 2019-08-03 21:34:01 +0200 )edit