SDK version 1804 released
asked 2018-06-06 18:37:18 +0200
Hello,
Today (Jun 8th) the 1804 SDK release was made available to all users.
If you have an older beta release of the SDK, you should see an update notification in the Sailfish OS IDE. View more information in the SDK wiki page and also check out the known issues page.
Happy hacking!
6.6.2018
The Sailfish OS SDK update 1804 has been released to Early Access. This update has the latest 2.2.0.29 build environment, which matches the Jolla Release 2.2.0 (Mouhijoki). It also contains lots of bugfixes and adds the ability to change the SSH and HTTP ports used by the SDK Build Engine and Emulator. Find out more about these features and the release content from the release notes.
Note for Early Access users:
It was discovered only after publishing the installers and repositories to Early Access, that the build Targets included in the Early Access release were corrupted.
This was fixed on Thursday, Jun 7, at 12:00 UTC. If you installed/upgraded to version 1804 before that time, you can fix your installation with these steps:
- Start Qt Creator and switch to the Sailfish OS mode (Control Centre)
- Remove the two preinstalled build Targets (SailfishOS-2.2.0.29-armv7hl and SailfishOS-2.2.0.29-i486). Remove just the Targets, preserve the Tooling
- Install the Targets again using the controls below
Apologies for the inconvenience.
When I type a
Damien Caliste ( 2018-06-06 19:14:50 +0200 )editmb2 -t ... buildcommand in the build engine, connected via ssh, I got:Warning: No repositories defined. Operating only with the installed resolvables. Nothing can be installed.and operation fails because of missing dependencies. Is there a new procedure to follow?@damien Same here :(
Dylan Van Assche ( 2018-06-06 20:20:08 +0200 )edit@damien-caliste @dylan-van-assche That's bad. A hardware error (as it seems) caused that the SDK build targets were corrupted during build. Since it was the very last RC with very limited changes, it was also not discovered by testing. Fix ongoing.
martyone ( 2018-06-07 10:01:51 +0200 )edit@martyone no problem, thanks for the fix, will test this evening. After all EA is used for this also.
Damien Caliste ( 2018-06-07 15:22:42 +0200 )edit@martyone, indeed the problem has been fixed. Following the steps above allow to compile again. Thank you.
Damien Caliste ( 2018-06-07 21:18:57 +0200 )edit