Connectivity problem XA2 (H4113) - Sailfish 3.0.1.11
Mobile connectivity was so bad in 3.0.0.8 that I have not been able to use my XA2 (H4113) and now it is even worse after upgrading to 3.0.1.11…
It is searching for network for 5-10 minutes before connecting to the provider network, after connecting it disconnects from time to time, and it is almost totally unable to connect to Mobile Broadband. I can bee lucky that it from time to time manages to establish a mobile broadband connection but it is very slow and disconnects all the time. When trying to establish the broadband connection the status is all the time flipping between “Connected” and “Connecting”. I tried two different sim’s from different providers both has the same problem in the XA2 but works fine in my X, my AquaFish and my Jolla 1.
I have again after this release sent in a ofono-log, like I did last time and I hope someone will have a look at it.
It is not possible to use my XA2 at all… Does anyone else have this connectivity problem or is it my phone? (which was tested a lot and was fully functioning using Android before flashing, and everything except connectivity works OK).
I have similar problem time to time but restarting usually helps.
Cannond ( 2019-01-18 20:26:54 +0200 )editMight be the same problem as with Xperia X where you have to reflash it with android, use voice calls and data for some time with the same sim you'll use it with and then reflash back.
butler ( 2019-02-02 03:49:00 +0200 )edit@butler As described in some of the comments below I did all that, and more, with very little effect. But please read my own reply to the question below – everything works fine after updating to 3.0.1.14.
DK-Sailor ( 2019-02-02 12:12:57 +0200 )edit@butler I don't understand the magic behind this
'reflash Android, install same SIM, use voice calls and data, then reflash'.
There is no magic, it's not Windows, and for a reason. These phones are supposed to be deterministic and these problems are supposed to have a clear cause. Apparently somewhere in a configuration and I don't understand why Jolla hasn't figured out yet where we have to fix the configuration so it will work as it should.
arie_jolla ( 2020-08-21 16:58:46 +0200 )edit